
Gibraltar · Road Series
Gibraltar Super Multi-Clamp
The Gibraltar SC-GCSMC clamps to any 1.5-inch rack tube with 2 inches of gripping surface and accepts accessory arms from 5/8 to 1¾ inches. Both sides carry notched receivers that pair with a memory lock, so a position can be marked and returned to exactly.
Gripping surface is the spec that matters
A clamp holds by friction against the tube, and friction scales with contact area. That makes gripping surface the number to compare, and it is the difference between Gibraltar’s two clamps.
Standard multi-clamp — 1.5 inches of grip. Fine for a cymbal arm, a cowbell, a small pad.
Super multi-clamp — 2 inches of grip. For a rack tom, a large cymbal on a long boom, or anything heavy enough to rotate a smaller clamp under load.
The failure mode is specific and worth recognising: a clamp that is not slipping along the tube but is slowly rotating around it, so a cymbal that started level is tilted by the end of the set. More gripping surface is the fix. Tightening harder is not — past a point you are just deforming the tube.
Notched receivers and memory locks
Both ends of this clamp have notched receivers, and they pair with a memory lock.
A memory lock is a collar you fix at a chosen position so the part always returns to it. The notch is what stops the clamp rotating relative to the lock, so the angle is memorised as well as the height.
That is the difference between a rack that goes back together the same way and one that has to be dialled in every time. For a complicated setup it is the entire argument for a rack, and the clamps are where it lives.
The diameter range is why this is universal
Accepting arms from 5/8 to 1¾ inches covers essentially every accessory arm, tom post and cymbal tube any manufacturer makes.
That range is the practical reason Gibraltar became the default. A drummer with a Tama tom arm, a DW cymbal boom and a Pearl percussion mount can hang all three off one rack without adapters, because the clamp does not care whose arm it is.
Very little else in drum hardware works across brands like this.
Where a clamp saves you buying a stand
Worth saying plainly, because it is the cheapest upgrade in this catalogue: a clamp on an existing stand can replace a whole additional stand.
A splash or a small cymbal does not need its own tripod. Clamped to the upper tube of a stand that is already there, it costs a fraction of a stand, weighs 1.35 pounds instead of 11, and takes up no extra floor.
The limit is leverage. Hanging a heavy cymbal on a long arm off another stand’s tube transfers all that torque to a stand designed for one cymbal, and the result wobbles. Use clamps for light things and give heavy things their own legs.
Specifications
| Attribute | Value |
|---|---|
| Hardware | |
| Type | Rack clamp1 |
| Fits rack tube | 1.5 in1 |
| Gripping surface | 2 in2 |
| Accepts accessory arms | 5/8 to 1¾ in diameter2 |
| Receivers | Notched on both sides, pairing with a memory lock2 |
| Dimensions | 6¾ × 7 in2 |
| Weight | 1.35 lb2 |
| Warranty | 5 years2 |
| Standard multi-clamp | 1.5 in gripping surface, for lighter loads1 |
Where to find it
Some links below are affiliate links — if you buy through one, Drum Atlas may earn a commission at no extra cost to you. Commission never affects what we list or how we describe it. Full disclosure.
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec
- 2Tier 2 · Highretailer listing