Drum Atlas
Menu

Gretsch · USA Custom

Gretsch USA Custom Hammered Chrome Over Brass

  • Snare drum
  • flagship
  • current

The Gretsch USA Custom Hammered Chrome Over Brass (G4164HB) is a 14-inch snare drum on a large-hammered 1.2mm chrome-plated brass shell with 4mm die-cast hoops and 42-strand wires. The hammering breaks up the shell's overtones, giving a drier voice than Gretsch's smooth chrome-over-brass.

Updated 2026-09-11Sources

What hammering does to a metal shell

A smooth metal shell is a uniform cylinder, and uniform cylinders ring at predictable frequencies with long, coherent sustain. That ring is why a plain brass snare is bright and lively — and why it can also be difficult to control.

Hammering deforms the surface into hundreds of small irregular curves. No two regions of the shell are quite the same shape any more, so the overtones no longer line up and reinforce each other. They decay faster and interfere with one another instead.

The result is a drier drum with a shorter tail and a more focused fundamental. Gretsch’s own description — “slightly drier” than their smooth chrome-over-brass — is a fair summary, and this is the same mechanism that makes a hand-hammered cymbal more complex than a machine-hammered one.

The 42 wires

Most snare drums use 16 to 20 strands. This one uses 42.

More wires across the head means a denser, faster, more uniform response — the snare sound becomes a sheet rather than a set of individual strands, with very short ghost notes coming through cleanly. It also means more contact with the resonant head, so the drum is a little more damped and the sensitivity at very low volume is high.

Combined with the hammering, this is a deliberately controlled drum. Nothing about it is loose.

The die-cast hoops

At 4mm these are heavy even by die-cast standards. A die-cast hoop is a single poured piece rather than a bent strip of steel, so it is far more rigid, and it clamps the head’s edge much more firmly.

That gives a more focused sound with fewer overtones, a harder and more concentrated rimshot, and noticeably more consistent tuning — the head is held more evenly around its circumference.

The trade is that die-cast hoops damp the head slightly and cost more. They also hurt more when you catch one.

Where it fits

This is a studio and stage drum for players who want brass weight and projection without brass unruliness. Against a Black Beauty it is drier and more controlled; against a Supraphonic it is darker, heavier and considerably more expensive.

If you already own a bright, ringing metal snare and want the other end of the metal range without going to wood, this is the drum.

Specifications

Specifications
AttributeValue
Shell
Shell materialBrass, chrome-plated2
Shell thickness1.2 mm2
HammeringLarge-pattern, hand-applied2
Bearing edge
Bearing edge45°2
Hardware
Lugs102
Hoops4mm die-cast2
Throw-offLightning2
Butt plateAdjustable2
Snare side
Snare wires42-strand2
model
ModelG4164HB (14 × 6.5); G4160HB (14 × 5)2

Where to find it

Some links below are affiliate links — if you buy through one, Drum Atlas may earn a commission at no extra cost to you. Commission never affects what we list or how we describe it. Full disclosure.

Sources

Numbered footnotes in the spec table point here.

  1. 1Tier 1 · Primarymanufacturer spec

    USA Custom Metal snares

    Gretsch Drums · accessed 2026-09-11

  2. 2Tier 2 · Highretailer listing

    Gretsch 14×6.5 USA Custom Hammered Chrome Over Brass Snare Drum (G4164HB)

    Memphis Drum Shop · accessed 2026-09-11