Drum Atlas
Menu

Tama · Speed Cobra 910

Tama Speed Cobra 910 Twin Pedal

  • Pedal
  • pro
  • current

The HP910LWN is the double-pedal Speed Cobra: a chain drive on the round Rolling Glide LiteSprocket, a long footboard, and a Super Stabilizer frame 15mm wider at the shaft supports than the previous Cobra. A newly developed Super Spring lightens the start of the stroke, the Accu-Strike beater is moulded in butadiene rubber, and a Pedal Anchor keeps the left-side pedal in place.

Updated 2026-10-11Sources

Catalogue record. This entry carries specifications and their sources, and no written assessment — nobody has written one yet. Everything in the table below is sourced and marked the same way as anywhere else on the site. For entries that explain the design rather than only record it, see the anatomy pages or any model marked as a full entry.

Specifications

Specifications
AttributeValue
Pedal
ConfigurationDouble (HP910LWN); left-footed HP910LWLN1
DriveChain1
CamRolling Glide LiteSprocket — round, about 40% lighter than the previous Iron Cobra cam1
SpringSwivel Spring Tight with a Super Spring — less effort at the start of the stroke1
Return springCobra Coil — steel assist spring, movable fore and aft on the base plate1
FootboardLong Footboard — longer than the Iron Cobra's, with a smoother surface1
BearingsOiles bearing hinge; Speedo-Ring rocker cam with a built-in ball bearing1
BeaterAccu-Strike Cobra — butadiene rubber with a thicker rubber section1
Beater angleVari-Pitch holder — set independently of the footboard angle1
Heel hingeHinge Guard Block — two-piece footplate bearing hinge1
Hoop clampPara-Clamp II Pro — three-dimensional rubber grip, T-bolt at the side of the footboard1
FrameSuper Stabilizer — shaft supports 15mm wider, under-plate about 12mm wider than the previous Cobra1
AnchorPedal Anchor stabiliser on the outside frame1

Sources

Numbered footnotes in the spec table point here.

  1. 1Tier 1 · Primarymanufacturer spec

    Speed Cobra 910 Twin Pedal HP910LWN

    Tama · accessed 2026-10-11