Tama · Iron Cobra 900
Tama Iron Cobra 900 Twin Pedal Rolling Glide
The HP900RWN is the Iron Cobra 900 double pedal with the round Rolling Glide LiteSprocket in place of the offset Power Glide cam, which gives an even pull from the top of the stroke to the bottom. Everything else is the 900 chassis: Oiles bearing hinge, Swivel Spring Tight, Cobra Coil, Power-Strike Cobra beater, Para-Clamp II Pro and a Pedal Anchor on the outside frame.
Catalogue record. This entry carries specifications and their sources, and no written assessment — nobody has written one yet. Everything in the table below is sourced and marked the same way as anywhere else on the site. For entries that explain the design rather than only record it, see the anatomy pages or any model marked as a full entry.
Specifications
| Attribute | Value |
|---|---|
| Pedal | |
| Configuration | Double (HP900RWN)1 |
| Cam | Rolling Glide LiteSprocket — a true round sprocket, 40% lighter than the previous cam1 |
| Cam action | Smooth, consistent action through the stroke1 |
| Spring | Swivel Spring Tight — contoured assembly whose base swivels with the spring, keeping the pull straight1 |
| Return spring | Cobra Coil — steel return spring, repositionable on the footboard base plate1 |
| Bearings | Oiles bearing hinge on a 6mm shaft; Speedo-Ring rocker cam with a built-in ball bearing1 |
| Beater | Power-Strike Cobra — smaller, thicker head with an increased head-to-shaft distance1 |
| Beater angle | Vari-Pitch holder — set independently of the footboard angle1 |
| Heel hinge | Hinge Guard Block — two-piece footplate bearing hinge1 |
| Hoop clamp | Para-Clamp II Pro — three-dimensional rubber grip, T-bolt at the side of the footboard1 |
| Anchor | Pedal Anchor stabiliser on the outside frame, supplementing the floor anchor bolts1 |
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec