Tama · Dyna-Sync
Tama Dyna-Sync Twin Pedal
The HPDS1TW is the double-pedal Dyna-Sync, a direct drive using a double-link cam connection system. The upper section of the Slidable Cam moves to change the turning radius, the Sync-Coil return spring is 1.5 times the gauge of Tama's Cobra Coil, and footboard angle is set at a clam-shaped joint between linkage and footboard.
Catalogue record. This entry carries specifications and their sources, and no written assessment — nobody has written one yet. Everything in the table below is sourced and marked the same way as anywhere else on the site. For entries that explain the design rather than only record it, see the anatomy pages or any model marked as a full entry.
Specifications
| Attribute | Value |
|---|---|
| Pedal | |
| Configuration | Double (HPDS1TW); left-footed HPDS1TWL1 |
| Drive | Direct1 |
| Linkage | Double-link cam connection system1 |
| Cam | Slidable Cam — the upper section slides to change the turning radius1 |
| Rocker | Speedo-Ring — rocker cam with a built-in ball bearing1 |
| Spring | Swivel Spring Tight — the base swivels with the spring for a straight pull1 |
| Return spring | Sync-Coil — 1.5x heavier gauge steel than the Cobra Coil, sliding on the base plate1 |
| Beater | Dyna Beater — black felt, slightly tapered1 |
| Footboard | Angle adjustable at a clam-shaped joint between the linkage and the footboard1 |
| Bearings | Oiles self-lubricating bearing hinge — less friction than standard ball bearings1 |
| Heel hinge | Hinge Guard Block — two-piece footplate bearing hinge1 |
| Hoop clamp | Para-Clamp II Pro — three-dimensional rubber grip, T-bolt at the side of the footboard1 |
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec