Drum Atlas
Menu

Yamaha · DS Hardware

Yamaha DS-840 Drum Throne

  • Hardware
  • pro
  • current

The Yamaha DS-840 is a heavyweight drum throne with a 330 mm round seat on a large aluminium die-cast mount, standing on three double-braced wide-stance legs. Height is set on a screw rod between 460 and 650 mm.

Updated 2026-09-24Sources

Thirteen inches, in metric

Three hundred and thirty millimetres is thirteen inches, which is the standard drum-throne diameter — DW’s 5100 and 3100 tops are the same size, as is Gibraltar’s 9000 Series round seat.

That convergence is not an accident. Much smaller and the seat concentrates weight onto too little area; much larger and it starts to get in the way of a leg swinging over it, and of the hi-hat stand on the way past. Thirteen inches is where the trade lands for most adult players.

Yamaha’s own range brackets it: the DS-750 below at 300 mm, the DS-950 above with a square bench 480 wide. This is the middle, and the middle is where most drummers actually are.

Three legs, and the wide stance

A tripod cannot rock. Three feet define a plane, so it sits flat on a raked stage, on a wooden riser with a warped board, on a carpet over cables — with no adjustment and no thought.

What it gives up against a four-leg base is footprint for a given packed size, and Yamaha’s answer is the wide stance: legs that splay further out than usual, pushing the feet away from the centre line so the throne resists tipping.

Double bracing does the rest. Each leg becomes a triangle rather than a cantilever, which is what stops the base folding when something clips it.

Screw rod

The height sits on a thread, not a friction clamp. Every bass drum stroke is a small downward impulse into the throne, and a clamped post takes those impulses and slowly gives; a thread does not, because the load path runs through the helix rather than through a grip.

The cost is speed. Changing height means turning the seat rather than sliding it, which is why the entry DS-750 uses a clamp rod instead and why gas lifts exist further up other makers’ ranges.

For a player who finds a height and keeps it — which is most players, once they have found it — the thread is the right mechanism and there is nothing to maintain.

Where the weight went

Yamaha calls the DS-840 heavyweight, and the specification tells you where that weight is: a large die-cast seat mount and double-braced wide-stance legs.

Both are in the base and the mount rather than in the cushion. That is the correct place for it — mass under the seat is stability, mass in the seat is just more to carry — and it is the structural difference between this throne and the single-braced DS-750 that shares much of its geometry.

Specifications

Specifications
AttributeValue
Hardware
TypeDrum throne1
SeatRound, 330 mm diameter1
Seat mountLarge aluminium die-cast1
LegsThree, double braced, wide stance1
Height range460–650 mm1
Height adjustmentScrew rod1

Sources

Numbered footnotes in the spec table point here.

  1. 1Tier 1 · Primarymanufacturer spec

    Drum Thrones — Specs (DS-750, DS-840, DS-950)

    Yamaha · accessed 2026-09-24