Drum Atlas
Menu

Tama · 1st Chair

Tama HT530BCN 1st Chair Glide Rider Cloth Top

  • Hardware
  • pro
  • current

The Tama HT530BCN is a tripod-base drum throne with a cloth-topped Glide Rider seat, developed around the balance between softness and firmness rather than maximum cushioning. It weighs 5.9 kg and adjusts between 470 and 650 mm. A HYDRAULIX version, the HT550BCN, puts the same seat on a gas-lift base.

Updated 2026-09-24Sources

Seat hardness is the first thing you judge

Tama’s own framing of this throne is unusually direct: what determines the first impression of a drum throne is the hardness of the seat, and the drummer knows within a second of sitting down whether it fits.

That is worth taking seriously, because it is not obvious. A seat that feels luxurious in a shop is often too soft to play on — you sink into it, your pelvis rolls back, and the support your legs need to drive two pedals goes away. A seat that feels firm in the shop is frequently the one you can still play on at hour four.

The Glide Rider was developed by working through shape, foam material, the stretch of the cloth and the method of sewing as one problem, aiming at a balance between soft and firm rather than at either extreme.

What a cloth top changes

Most drum thrones are vinyl. Vinyl is durable, wipes clean, and survives a wet van — which is why it dominates.

Cloth breathes. Over a long hot set, a vinyl top traps perspiration between you and the seat, and what follows is the sliding that has you resetting your position between songs. A woven top lets the moisture through and gives the friction back.

The trade is care: cloth absorbs what vinyl sheds, and it wants a cover in a wet load-out.

Tripod or HYDRAULIX

The same seat sits on two different bases, and the choice is the familiar one.

The HT530BCN here is the tripod — a threaded-and-clamped post on three legs. Nothing in it can leak or sag, it packs flat, and it is the lighter of the two at 5.9 kg.

The HT550BCN HYDRAULIX puts the seat on a gas lift: the height changes by lever, with the seat detachable from the base for transport. Faster to adjust, easier to pack in two pieces.

The seat lock

Between the base and the seat is the joint every drummer has felt fail: the one that lets the top rotate a few degrees whenever you reach out.

Tama’s answer is a two-piece hinged collar clamping around the post with an oversized wing nut rather than a single screw pressing into it. A collar grips the whole circumference, and an oversized nut means your thumb — not the thread — stops being the limit on how tight it goes.

Specifications

Specifications
AttributeValue
Hardware
TypeDrum throne1
SeatGlide Rider, cloth top1
Height range470–650 mm1
Weight5.9 kg1
BaseTripod1
Height adjustment1st Chair — threaded rod with T-bolt1
Seat lockTwo-piece locking hinge collar with oversized wing nut1
Gas-lift versionHT550BCN HYDRAULIX1

Sources

Numbered footnotes in the spec table point here.

  1. 1Tier 1 · Primarymanufacturer spec

    1st Chair Glide Rider "Cloth Top" HT530BCN

    Tama · accessed 2026-09-24