Drum Atlas
Menu

Canopus · Other Hardware

Canopus Tom Stand, Holder and Clamp System

  • Hardware
  • pro
  • current

Canopus's tom mounting range is a set of stands, holders and clamps sharing a 13 mm L-rod: single and double tom stands, single and double tom holders on 25.4 mm posts, a cymbal holder whose boom retracts into its own shaft, and a clamp that accepts tubes from half an inch to an inch.

Updated 2026-09-24Sources

The clamp that takes half an inch to an inch

One number here does more work than the rest: the clamp accepts tubes from ½ inch up to 1 inch in diameter.

That range covers essentially every stand tube a drummer owns. A cymbal stand’s upper section, a hi-hat’s column, a snare stand’s middle tube, a rack bar — all fall inside it. So the clamp is not a Canopus accessory for Canopus stands; it is a clamp for whatever is already on the stage.

For a player adding a tom, a splash or a cowbell to a kit that was not designed to carry one, that is the whole question answered.

Thirteen-millimetre L-rods

The L-rod is the bent bar that goes into a tom’s bracket, and its diameter is the interface that decides whether a holder fits a drum.

Canopus standardises on 13 mm across the holders and the single tom clamp, which is close to the ½-inch (12.7 mm) standard most of the industry uses. One rod size across the range means a holder bought for a stand works on a clamp bought for a rack.

The posts differ by application: 430 mm on the single holder, 360 mm on the double, both 25.4 mm in diameter, because a double holder sits lower and carries two drums rather than reaching high with one.

The retracting cymbal boom

The CCH-1 cymbal holder’s boom section slides back into its own main shaft.

That is the same solution Sonor uses on the 4000 Series, Tama on the Roadpro and DW on the 9700 — a boom that becomes a straight post rather than a boom that comes off. Nothing detaches, so nothing is left behind, and the conversion between the two takes a moment.

On a holder rather than a full stand it matters more, because a holder is already being used in a tight space: the point of hanging a cymbal off a clamp is usually that there was no floor for a stand.

Stands as well as holders

The CSTS-2 single and CWTS-2 double tom stands cover 500 to 870 mm and 500 to 800 mm respectively.

Those are floor-standing versions of the same idea, for players who mount toms off stands rather than off the bass drum — which is the norm on a kit where the bass drum is left unpierced, and on any kit assembled from drums that did not come with brackets.

Specifications

Specifications
AttributeValue
Hardware
TypeTom stands, holders and clamps1
Clamp capacityAccepts tubes from ½ in to 1 in diameter1
L-rod13 mm on the tom holders and single tom clamp1
Holder posts25.4 mm — 430 mm on the CSTH-2 single, 360 mm on the CWTH-2 double1
Stand height500–870 mm1
Cymbal holderCCH-1 on a 19 mm by 310 mm post, boom retracting into the main shaft1
ModelsCSTS-2 and CWTS-2 stands; CSTH-2, CWTH-2 and CCH-1 holders; CSTP-1 clamp1

Sources

Numbered footnotes in the spec table point here.

  1. 1Tier 1 · Primarymanufacturer spec

    Tom Stand / Holder / Clamp

    Canopus · accessed 2026-09-24