
Remo · Powerstroke 3
Remo Powerstroke P3 Fiberskyn
The Remo Powerstroke P3 Fiberskyn is a bass drum head of film laminated to a 3-mil polyspun fibre face, with a 2-mil inlay ring for overtone reduction. Remo builds it on 7.5-mil Diplomat or 10-mil Ambassador film, and lists a focused warm tone with enhanced low-frequency definition and controlled overtones.
A skin-faced bass drum head with a ring in it
Two ideas that do not usually meet. Fiberskyn is film with a 3-mil polyspun fibre mat bonded to the playing face — a synthetic calfskin, warm and soft, built for concert and vintage-voiced work. Powerstroke is a perimeter inlay ring, built to stop a bass drum ringing.
Putting them together produces a bass drum head that is both warm at the surface and controlled at the edge, which is a genuinely useful combination for anyone chasing an old bass drum sound without stuffing the drum full of blankets.
A lighter ring than the rest of the range
Worth noting because it is unusual: this head carries a 2-mil inlay ring, where most P3 bass heads carry 10 mil.
That is a deliberate decision and a sensible one. The fibre face is already damping the top of the spectrum — that is what a fibre face does — so a heavy ring on top of it would over-damp the head and lose the low-frequency definition Remo is claiming. Two mil takes the last of the edge ring off and stops there.
The phrase on the page is slightly dampened high-frequency overtones, which is a more modest claim than the rest of the P3 range makes, and it matches the lighter ring.
Two film weights under one name
Remo builds this on either 7.5-mil Diplomat film or 10-mil Ambassador film, depending on the head. That is worth checking against the part number when ordering, because the difference is real: the lighter substrate is more responsive and tunes lower comfortably, the heavier one takes a harder beater.
Both carry the same 3-mil fibre lamination.
What it sounds like under a beater
A felt beater on a fibre face produces almost no click at all — the transient arrives as a woody thump. Remo’s description, focused warm tone with enhanced low-frequency definition, is the honest one: taking the high overtones out of a bass drum makes its pitch easier to hear, not harder.
Where it fits
Jazz and vintage-voiced bass drums, and studio work where the drum has to sound like an old record. The Felt Tone Fiberskyn is the same surface with a free-floating felt strip instead of an inlay ring; the P3 Renaissance is the treated-film route to a similar warmth.
Specifications
| Attribute | Value |
|---|---|
| Heads | |
| Plies | 11One ply of film, laminated to a 3-mil polyspun fibre layer. |
| Film thickness | 7.5 or 10 mil1Remo builds this head on 7.5-mil Diplomat film or 10-mil Ambassador film, plus a 3-mil polyspun fibre lamination. |
| Coating | Textured — Fiberskyn fibre laminate1 |
| Position | Batter or resonant1 |
| Dampening | 2-mil inlay ring for overtone reduction1 |
| Intended use | Bass drum1 |
| Character | Focused warm tone with enhanced low-frequency definition and controlled overtones1 |
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec