
Aquarian · Super Kick
Aquarian Super Kick II
The Aquarian Super Kick II is two plies of 7-mil NuBrite film with a narrow felt muffle ring attached so that it floats with the head rather than resting on it. The ring moves as the head moves, damping overtones without pinning the film down.
A muffle ring that moves
Every other edge-damping system in this catalogue holds still while the head moves past it. The ring — bonded, folded, or mounted — is a fixed object that the film has to work against.
Aquarian’s Floating Muffling System attaches the felt ring so that it travels with the film instead. The ring rises and falls as the head does, damping through its own inertia and its contact with the film rather than by clamping the head down.
Aquarian’s own phrasing is that the head still gets to breathe, and that is a reasonable description of the audible result. A pinned edge takes the overtones out and takes some of the drum’s air with them; this takes the overtones out and leaves the low end moving.
It is the sort of idea a small independent company arrives at and a large one does not — see the brand page for why that pattern repeats here.
No blanket required
The practical claim, and it holds up: this head is intended to make internal muffling unnecessary.
The conventional bass drum setup is a pillow or blanket pressed against the batter head, the front head, or both. It works, and it costs you dynamic range — a pillow damps a quiet stroke exactly as hard as a loud one, which is why heavily muffled bass drums sound like a single volume.
Two plies plus a floating ring gets most of the way to a controlled sound while leaving the drum responsive. For a lot of players that means an empty bass drum for the first time, which also means a lighter drum to carry and no blanket sliding around inside it during a set.
Super Kick I, II and 10
The line is numbered by weight and it is worth knowing which is which:
- Super Kick I — single ply, with the floating ring. Most open, most attack.
- Super Kick II — two plies of 7 mil. The middle, and the one most players want.
- Super Kick 10 — heavier again, for maximum low end and minimum ring.
The ring system is the same across all three. What changes is the film underneath it.
Against the Evans EMAD
These are the two bass drum batters most professionals choose between, and they take opposite routes.
EMAD — single ply, damping mounted externally, two ring widths, adjustable in seconds. Brighter, more attack, and you can retune the damping room by room.
Super Kick II — two plies, damping built in and not adjustable. Warmer, fatter, and one less thing to think about.
Neither is better. The question is whether you want a system or a sound.
What it sounds like
Full and punchy with the high end pulled back and a strong low fundamental. The attack is softer than an EMAD’s — two plies of film absorb more of the beater’s click — and the note is rounder.
The texture-coated versions warm it further and are the choice if the clear version reads too hard on the attack.
Specifications
| Attribute | Value |
|---|---|
| Heads | |
| Plies | 21 |
| Film thickness | 7 mil1 |
| Film | NuBrite1 |
| Dampening | Floating Muffling System — narrow felt ring that moves with the head1 |
| Position | Bass drum batter1 |
| Size range | 14 to 28 in1 |
| Hoop | For standard bass drum hoops1 |
| Coating | Clear, or texture coated1The cited page gives the clear model and states that white and black texture coated finishes are also offered. |
Where to find it
Some links below are affiliate links — if you buy through one, Drum Atlas may earn a commission at no extra cost to you. Commission never affects what we list or how we describe it. Full disclosure.
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec
- 2Tier 2 · Highretailer listing