
Liberty Drums · Solid Block
Liberty Drums Solid Block Series Snare
The Solid Block Series is Liberty's plain-colour snare: a fifteen-ply Finnish birch shell with 45-degree bearing edges, in 14x5.5 or 14x6.5, fitted with Liberty's chrome Bridge lugs, 2.3mm ten-hole triple-flanged hoops and a Dunnett R7 throw-off. Finishes are solid colours in matte or high-gloss lacquer, specifiable by RGB or CMYK value.
Fifteen plies
Fifteen is a lot. A standard snare shell is six to eight plies and around 7mm; this one stacks more than twice that count.
What a very thick shell does is stop moving. Almost none of the head’s energy is absorbed by the wall, so it comes back as attack and as head tone: a loud, focused, short drum with a high fundamental and very little of the woody bloom a thin shell gives.
That is a specific instrument rather than a general-purpose one. A fifteen-ply birch snare is built to cut — to sit in a dense mix and still be heard — and it will do it at volumes where a thin shell would have given up and started to choke.
Birch, specifically Finnish
Liberty builds the range in Finnish birch and says so on every product page.
Birch’s character is a scooped midrange: more top, more bottom, less in between than maple. That is why it became the studio wood, and why a birch drum tends to sound as though it has already been EQ’d.
Finnish birch is the northern-grown stock, slow-grown in a short season, which gives tight, even growth rings and a consistently dense sheet. It is the grade the Baltic plywood trade is built on, and it is why a Finnish birch shell laminates cleanly at fifteen plies without the thickness variation that would put a thick shell out of round.
Forty-five degrees
A sharp 45-degree edge puts the smallest possible area of wood against the head.
Less contact means less damping at the edge and more of the head’s energy staying in the head, which gives a bright, open, articulate drum with plenty of overtone. Rounded edges do the opposite: more contact, more warmth, less ring.
On a fifteen-ply shell, a 45-degree edge is consistent with everything else. This is a drum designed around clarity, and the edge is the part of that decision the tuner feels most directly.
Dunnett R7 and a colour of your choosing
The throw-off is a Dunnett R7 — a machined, side-lever mechanism from the Canadian maker whose strainers are bought by other builders and by players upgrading their own drums. It is the fitting you specify when you do not want the strainer to be the part that fails.
The finish, by contrast, is where the line gets playful. Solid blocks of colour, matte or gloss, and Liberty will mix to any RGB or CMYK value you give it. That is an unusual offer and a modern one: the customer supplies a hex code rather than choosing from a chart.
Specifications
| Attribute | Value |
|---|---|
| Shell | |
| Shell material | 100% Finnish birch1 |
| Plies | 151 |
| Finish | Solid colour lacquer, matte or high gloss; any RGB or CMYK value to order1 |
| Bearing edge | |
| Bearing edge | 45°1 |
| Hardware | |
| Lugs | Liberty Chrome Bridge1 |
| Hoops | 2.3 mm chrome triple-flanged, ten hole1 |
| Throw-off | Dunnett R71 |
| Origin | |
| Made in | United Kingdom2 |
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec
- 2Tier 1 · Primarymanufacturer spec