Drum Atlas
Menu

Liberty Drums · Richmond

Liberty Drums Richmond Series

  • Drum kit
  • custom
  • current

The Richmond Series is Liberty's made-to-order kit in Finnish birch, with full-contact bearing edges and internally chamfered reinforcement rings. Bass drums run 18x14 to 24x15, and the line includes a 15-inch floor tom pitched to cover a 14-to-16-inch tuning range. Liberty's own Beetle lugs and 2.3mm triple-flanged hoops throughout; about twelve weeks to build.

Updated 2026-09-24Sources

The fifteen-inch floor tom

The most interesting drum in the line is the one nobody else stocks.

Floor toms come in 14, 16 and 18. Liberty offers a 15, and states its case directly: it covers the tuning range a 14 and a 16 would between them.

That is a real claim about a real problem. A 14-inch floor tom tuned low gets slack and loses pitch definition; a 16 tuned up gets choked and loses its bottom. The 15 sits where both are comfortable, which means one drum instead of two for a player who wants a three-piece kit to cover more ground.

Odd sizes exist because someone is cutting shells to order rather than ordering them by the pallet.

Full contact, not forty-five

The kit edges are full contact, and that is the opposite decision from the Solid Block snare’s sharp 45.

A full-contact edge presents a broad, rounded surface to the head. More wood touches the head, so more energy goes into the shell and less stays in the membrane: the drum is warmer, rounder, shorter in sustain and easier to tune low.

On birch — a hard, bright wood — that is a deliberate counterweight. Birch’s top end is the thing a recording engineer likes and a room sometimes does not, and a full-contact edge takes some of it back.

Chamfered on the inside

The reinforcement rings are internally chamfered: cut away at an angle on the inside face rather than left as a square block of wood at each end of the shell.

A re-ring’s job is to keep the shell round under tension, and a square ring does that while also adding a sudden step in the shell’s inner wall. Chamfering it removes the step, so the air inside the drum meets a gradual taper instead of a shelf, and the ring’s mass is concentrated where it does structural work.

Combined with the full-contact edge this is a shell designed for warmth and control rather than for ring — and it is also, in miniature, the difference between a kit built by someone who thinks about the inside of a drum and one who does not.

Bass drums, and one that costs extra

Eighteen by fourteen, twenty by fifteen, twenty-two by fifteen, twenty-four by fifteen.

Three of the four share a 15-inch depth, which is the modern middle: deep enough to develop, shallow enough to stay punchy. The 18 is 14 deep and is a bop drum; the 24 adds £900 to the price of a kit, which is what happens when a shell goes outside the sizes the shop has set up for.

Toms hang on Liberty’s own basin mount with a Gibraltar single-ball L-rod carrying a cymbal arm, so the tom and a crash come off the bass drum on one post.

Specifications

Specifications
AttributeValue
Shell
Shell material100% premium Finnish birch1
Reinforcement ringsInternally chamfered re-rings1
Bearing edgeFull contact1
Hardware
LugsLiberty Chrome Beetle1
Hoops2.3 mm chrome triple-flanged, on every drum1
Tom mountBasin-mounted tom on a Liberty bracket, with a Gibraltar single-ball L-rod carrying a cymbal mount1
Build
BuildMade to order, about 12 weeks; custom sizes available1
Origin
Made inUnited Kingdom1
kit
Bass drums18 × 14, 20 × 15, 22 × 15 and 24 × 15 in1

Sources

Numbered footnotes in the spec table point here.

  1. 1Tier 1 · Primarymanufacturer spec

    Richmond Series

    Liberty Drums · accessed 2026-09-24