Vic Firth · Soundpower
Vic Firth Soundpower GB2 Small Gong Beater
The Vic Firth Soundpower GB2 is a gong beater with an oval fleece-covered head measuring 4¼ by 2⅛ inches, on a 16½-inch maple handle. Vic Firth specify it for small gongs, gamelan and tuned gongs.
Small gong, large head
The naming is about the instrument, not the beater, and the dimensions make that clear: the GB2’s head is 4¼ inches on its long axis — the same as the GB1 for large gongs.
What changed is the shape. The GB1’s head is round; this one is oval, 4¼ by 2⅛. Half the width on the short axis.
Why an oval suits a small gong
Because the contact patch has to fit the instrument.
A gong responds to where it is struck. The centre gives the fundamental; nearer the rim gives more upper partials. On a 40-inch tam-tam a 4-inch round head is a small, well-defined spot and the player can choose.
On a 10-inch gong — or a gamelan kettle, or a tuned gong in a set — the same head covers a large fraction of the whole instrument. The stroke stops being a choice of location, and energy spills into modes the player did not want.
An oval keeps the mass of a large head, which is what produces a soft, low-frequency bloom, while presenting a narrower contact patch across the instrument. Weight without footprint — the same trick Gauger’s TG03 Molto uses on a bass drum, for a different reason.
Tuned gongs and gamelan
Both are pitched, and that changes the requirement. A pitched instrument wants its fundamental to develop, which means a soft, sustained contact rather than a sharp one; the fleece covering is what supplies it.
Gamelan instruments are also played in sets, often quickly. The 16½-inch handle — shorter than the GB1’s 17¼ — is less to move between kettles, and a shorter lever is easier to place accurately on a small target.
Where it is the wrong beater
A full tam-tam stroke. The oval presents too little area to excite a large plate’s broad modes properly, so the bloom is thinner than the GB1 would give. The range has four beaters because gongs are not one instrument.
Specifications
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec