Drum Atlas
Menu

DW · 6000 Series

DW 6300 Flush Base Snare Stand

  • Hardware
  • pro
  • current

The DW 6300 is a low-profile snare stand built in aluminium on a flush base, with the drum angle held by a recessed locking wing screw and hinged memory locks at the tube joints. It is the lightweight stand in DW's range, aimed at players carrying their own hardware.

Updated 2026-09-24Sources

Aluminium, and what that trades

Almost all drum hardware is steel with chrome over it. Aluminium is roughly a third the density, so a stand built from it weighs a fraction of its steel equivalent for the same tube diameters.

The trade is stiffness. Aluminium’s elastic modulus is about a third of steel’s too, which means a tube of the same size flexes further under the same load. Hardware designers answer that by making aluminium tubes fatter rather than thicker — you see it on this stand and across the Ultralight range — so the section regains its rigidity while staying light.

What is left of the difference shows up as a stand that moves a little more when it is knocked and weighs a great deal less when it is carried. For a player doing three sets and their own load-in, that is not a compromise; it is the point.

The recessed wing screw

Snare angle is set by a joint in the basket, and the failure mode everyone knows is a stand that gradually flattens under rimshots.

Recessing the wing screw does two things. It puts the screw head below the surrounding casting, so a stick that comes down on the edge of the basket hits metal rather than the screw — a wing screw sticking out of a snare stand is the most reliably-broken part on a kit. And it lets the screw be done up hard without the head fouling anything, which is what actually keeps the angle.

Flush base under a snare

The flush base matters more here than anywhere else on the kit, because the snare stand sits in the busiest square foot of floor there is: hi-hat legs on one side, a bass pedal and possibly its slave in the middle, the throne behind.

Legs that lie flat against the floor slide under the other hardware instead of arguing with it. The setup gets tighter, the snare goes where you actually want it, and the hi-hat can come in closer than a tripod would allow.

Specifications

Specifications
AttributeValue
Hardware
TypeSnare stand1
BaseFlush base, low profile1
MaterialAluminium1
Angle lockRecessed locking wing screw1
Memory locksHinged, at the tube joints1

Sources

Numbered footnotes in the spec table point here.

  1. 1Tier 1 · Primarymanufacturer spec

    DW 6000 Series Flush Base Snare Stand — DWCP6300

    Drum Workshop · accessed 2026-09-24