
Remo · Powerstroke 3
Remo Powerstroke P3 Ebony
The Remo Powerstroke P3 Ebony is one ply of 10-mil Ebony film with a 10-mil inlay ring at the perimeter. The ring damps the edge overtones and leaves the fundamental, giving midrange and low-end resonant tone. Remo calls it its most popular resonant bass drum head, in sizes from 16 to 26 inch.
The front head, specifically
Most of the Powerstroke range gets described as a batter head. Remo’s own framing of this one is different: it calls the P3 Ebony its most popular resonant bass drum head, and that is worth taking at face value because it changes how to think about it.
A bass drum’s front head is not struck. It is driven by the air the batter moves, and its job is to decide how long the drum rings and how much low end survives. It is also the largest visible surface on the kit.
Ten mil of Ebony film with a 10-mil inlay ring answers both. Black, matte, logo-free, and pre-damped.
What the inlay ring does
The ring is a band of film bonded around the perimeter — here 10 mil of it, which is thick, because bass drum heads need more damping than toms.
The perimeter is where a head’s high, tight overtones live. The centre is where the fundamental lives. Damping the edge therefore removes the ring without touching the note, which is the whole design of the Powerstroke family and the reason a Powerstroke head sounds fat rather than dead.
Remo’s description — midrange and low-end resonant tones — describes exactly that: the top is gone, the middle and bottom are intact.
Whole, or ported
A P3 Ebony front head left whole gives the drum its longest, deepest note. The two heads couple through the air column and the drum breathes.
Cut a port in it and everything changes: the coupling breaks, the sustain shortens dramatically, and a microphone can go inside. The inlay ring keeps working either way, since it is damping the head’s own edge rather than the drum’s resonance.
Ebony film hides a port far better than white or clear, which is a practical reason a lot of ported bass drums have a black front head.
As a batter
It works perfectly well — 10 mil with a ring is a standard bass batter construction. The difference against the clear or coated P3 is only the surface: no coating to wear through where the beater lands, and no clear window showing the inside of the drum.
Where it fits
Bass drums 16 to 26 inch, front or batter, on kits that should read black. The P3 Black Suede is the textured matte version; the clear and coated P3 heads are the same construction with a different face.
Specifications
Where to find it
Some links below are affiliate links — if you buy through one, Drum Atlas may earn a commission at no extra cost to you. Commission never affects what we list or how we describe it. Full disclosure.
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec