
Remo · Powerstroke 3
Remo Powerstroke P3 Coated Black Dot
The Remo Powerstroke P3 Coated Black Dot is one ply of 10-mil coated film with a 10-mil inlay ring and a black dot underneath the centre. The ring takes the edge overtones off, the dot reinforces where the beater lands, and the coating rounds the attack: midrange and low-end resonance with increased durability.
Three interventions, three different jobs
Worth separating out, because this head is often described as simply “damped” when in fact each part does something distinct.
The 10-mil inlay ring sits at the perimeter. That is where a head’s high, tight overtones live, so damping there removes the ring while the fundamental at the centre survives.
The bottom black dot sits under the beater’s contact area, stiffening and reinforcing the small region that does the mechanical work.
The coating covers the playing surface, adding mass that softens the beater transient and shortens what is left of the decay.
Remo’s summary is midrange and low-end resonant tones with increased durability — control from the ring, warmth from the coating, life from the dot.
Why the dot is underneath here
Remo specifies a bottom dot on the coated version and a top dot on the clear one, which is a consistent pattern across the range and a sensible one.
A dot on top is the most durable arrangement, because the beater never touches the base film. But it also replaces the playing surface — and on a coated head the coated surface is the reason you bought it. Putting a dot over it would hand back the warmth the coating provides.
Underneath, the beater meets coating as normal and the dot does its stiffening from below. A little less durable than a top dot; considerably more consistent with the rest of the head’s design.
What this gets you over the plain coated P3
Mostly life, and some punch. A plain coated Powerstroke P3 is one of the standard bass drum batters in the world and it wears out at the beater spot. Adding a dot there extends that considerably and firms up the front edge of the note as a side effect.
If your bass batters are dying at the contact point rather than losing their tone, this is the straightforward answer.
Where it fits
Bass drum batters 18 to 26 inch on kits played hard, where the sound should stay warm. The clear version keeps more attack and puts the dot on top. Remo credits the design’s inspiration to Steve Smith.
Specifications
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec