Drum Atlas
Menu

ddrum · SE Flyer

ddrum SE Flyer Pitstop

  • Drum kit
  • intermediate
  • current

The Pitstop is the smaller of ddrum's two SE Flyer configurations: a 15 x 16 in bass drum, a 7 x 10 in rack tom, a 12 x 13 in floor tom and a 6 x 13 in snare, in the same 6-ply poplar toms and 8-ply poplar bass drum as the bop kit, with the same bass drum lift and wood hoops.

Updated 2026-09-24Sources

A 16-inch bass drum that is 15 inches deep

The Pitstop’s bass drum is nearly square: 16 in across, 15 in deep. That is an unusual shape and a deliberate one.

Taking the diameter down to 16 in removes most of the low fundamental a bass drum normally produces. Keeping 15 in of depth puts back the air volume that a 16 x 10 in travel kick gives away, so the drum still has body behind the attack instead of being a short slap. The result sits higher in pitch than a conventional kick and fuller than its diameter suggests.

Like the bop-sized SE Flyer, it comes with a lift, because a 16 in drum on the floor puts the beater well below the centre of the head.

Everything shifted down a size

Against the SE Flyer bop configuration, each drum steps down: 10 in rather than 12 in rack tom, 13 in rather than 14 in floor tom, 13 in rather than 14 in snare. The intervals between them stay similar, so the kit keeps its internal balance while occupying noticeably less floor.

The snare is the drum that changes character most. A 6 x 13 in is deeper than the bop kit’s 5.5 x 14 in and narrower, which trades some sensitivity at low volume for a fatter, lower crack.

Shared with the SE Flyer

The shell, the edges, the hoops, the lugs, the heads and the mounting hardware are all the same, as are the improvements ddrum lists across the series: gull-wing bass drum spurs, a redesigned snare throw-off, floor tom memory locks and an included cymbal boom.

That makes the choice between the two purely about size. Both draw from the same add-on parts list, so a Pitstop can be grown into a bop kit later.

Specifications

Specifications
AttributeValue
Shell
Shell materialPoplar1
Plies6-ply toms; 8-ply bass drum1
Bearing edge
Bearing edge45 degrees1
Hardware
Hoops1.6 mm triple flanged; natural lacquer wood on the bass drum1
LugsSingle point round, low mass1
Tom mountDirect to shell, with a double tom holder1
kit
IncludedBass drum lift, tom arm and boom arm, Remo UT coated heads1

Sources

Numbered footnotes in the spec table point here.

  1. 1Tier 1 · Primarymanufacturer spec

    SE Flyer Pitstop 4pc Shell Pack White Pearl

    ddrum · accessed 2026-09-24