Yamaha · Professional
Yamaha YX-500 Xylophone
The YX-500 is Yamaha's 3½-octave professional xylophone, F45 to C88, offered with rosewood bars as the YX-500R or Acoustalon synthetic bars as the YX-500F. Bars are non-graduated at 1⅝ in across the range, and the frame folds for transport with a gas-shock height adjustment.
A xylophone is not a small marimba
Both are wooden bars over resonators, and that is where the resemblance ends. The bars of a xylophone are tuned so that a prominent overtone sits a twelfth above the fundamental, where a marimba bar’s is two octaves above; the xylophone’s arch is cut differently to achieve it. The result is the bright, hard, carrying sound that reads through a full orchestra, played with hard mallets and written an octave below where it sounds. A marimba is warm and blends; a xylophone cuts. Substituting one for the other does not work.
Rosewood or Acoustalon
The YX-500R has rosewood bars, the traditional material, and the YX-500F has Yamaha’s Acoustalon — a synthetic bar material Yamaha describes as resilient to climate change. A wooden bar moves with humidity and can crack; a synthetic one does not, which is why synthetic-barred instruments are standard in marching and outdoor settings and common in schools. The rosewood instrument is 78 lb, the Acoustalon 84.
Bars that do not graduate
Unusually, the bars are a constant 1⅝ in wide across the whole instrument rather than widening toward the bottom, and Yamaha states the bar sizing was chosen for consistent tone quality throughout the range. The resonator rail is cut away and carries only the accidental resonators that are actually needed, which keeps the instrument short — 54⅜ in — and light.
Getting it to the gig
The frame folds, and a gas shock takes the height between 31½ and 37⅜ in with no tools and one person. At under 80 lb this is among the more portable concert mallet instruments, which is much of why it turns up in pit orchestras and touring shows.
Specifications
| Attribute | Value |
|---|---|
| perc | |
| Type | Xylophone1 |
| Range | 3½ octaves, F45–C881 |
| Bars | Rosewood on the YX-500R; Acoustalon synthetic on the YX-500F1 |
| Bar sizes | Non-graduated, 1⅝ in1 |
| Resonators | Cutaway design in brushed tan, with only the essential accidental resonators1 |
| Pitch | A = 442 Hz; other pitches to special order1 |
| Height adjustment | 31½ to 37⅜ in, gas shock1 |
| Weight | 78 lb for the rosewood, 84 lb for the Acoustalon1 |
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec
- 2Tier 1 · Primarymanufacturer spec