Vic Firth · Brushes
Vic Firth Steve Gadd Wire Brush
The Vic Firth Steve Gadd Wire Brush has its wires angled at the playing end so they glide across a coated head instead of catching on it. The current version revises that angle, and the pull rod carries a third crimp for an additional spread setting.
An angle that solves a specific problem
Coated drumheads have a textured surface, and that texture is what makes a brush sweep audible at all. It is also what makes a brush snag.
A wire coming off the fan roughly perpendicular to the head digs into the coating. Under a sweep it catches, releases and catches again, and the result is a scratch rather than a wash.
Gadd and Vic Firth’s fix was to angle the wires at the playing end, so they meet the head closer to flat and skate over the texture instead of into it. The current brush revises that angle again, for what Vic Firth describe as a smoother sweep.
Why it matters more than it sounds
A brush sweep is a sustained sound, and sustained sounds expose every irregularity. One wire catching once per revolution is clearly audible, and there is nothing a player can do about it except change the angle of the whole hand.
Solving it in the geometry of the brush rather than in the technique is the better engineering answer.
The third crimp
The pull rod that retracts the wires has crimps along it — detents where the mechanism holds position. Two gives you a fully fanned setting and a closed one; a third gives an intermediate spread that stays put.
Spread is the brush player’s main tonal control, since it sets the width of the contact patch. An extra reliable stop is a small feature that gets used constantly.
The Gadd thread
Gadd’s name appears twice in this catalogue’s stick section. His signature stick is built around rebound and control; this brush is built around removing a mechanical obstacle. Both are the same instinct — take away what is in the way of the sound.
Specifications
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec