Drum Atlas
Menu

Pearl · Session Studio Select

Pearl Session Studio Select Snare

  • Snare drum
  • pro
  • current

The Pearl Session Studio Select snare is a 14 × 6.5-inch drum on a 6-ply, 5.4mm shell of birch over African mahogany, cut with a 60-degree bearing edge and hooped with 2.3mm triple-flanged SuperHoop II rims. The 60-degree edge is unusual and is the line's distinguishing feature.

Updated 2026-09-24Sources

Sourcing note

Pearl’s own pages do not serve this project — blocker B6 — so this record is built from a retailer listing and every spec is marked unverified. The strainer model and wire count are not stated there and are left out.

A 60-degree bearing edge

Almost every modern drum is cut at 45 degrees, and the older American convention was 30. Sixty is a genuine outlier, and it works the opposite way to the usual assumption: a steeper angle leaves less shell under the head, not more.

The narrower contact patch means the head is supported on a fine line, which sharpens the attack and tightens the drum’s fundamental. Pearl’s stated intent is controlled punch, and a steep edge is the mechanism.

Birch over African mahogany

Four plies of birch outside and two of African mahogany inside, at 5.4mm total. That is a thin shell by modern standards, and the two species do different jobs: birch supplies the high-end lift and the fast decay that makes it the classic studio wood; mahogany fills the low mids that birch alone leaves thin.

The combination is often described as pre-equalised, which is a fair way of saying it arrives shaped in a way a microphone tends to like.

Where the line came from

Pearl positions Session Studio Select as a trickle-down from Masterworks, its custom range. The thin hybrid shell, the steep edge and the triple-flanged rather than cast hoops all point the same way: a drum designed to be recorded rather than to be loud.

Specifications

Specifications
AttributeValue
Shell
Shell materialBirch and African mahogany1*Stated by Drum Center of Portsmouth; not confirmed against a Pearl specification sheet.
Plies61*Retailer listing only.
Shell thickness5.4 mm1*Retailer listing only.
Shell finishDelmar USA wrap1*Retailer listing only.
Bearing edge
Bearing edge60°1*Retailer listing only.
Hardware
Hoops2.3mm triple-flanged SuperHoop II1*Retailer listing only.
model
ModelSTS1465S1*Pearl's own site is unreachable for this project; the code is taken from a retailer listing.
  • *Not yet checked against a published source. Where a numbered source is given, it is on record but has not been opened and confirmed. See how we source.

Sources

Numbered footnotes in the spec table point here.

  1. 1Tier 2 · Highretailer listing

    Pearl Session Studio Select 14x6.5 Snare Drum

    Drum Center of Portsmouth · accessed 2026-09-24