
Mapex · Black Panther
Mapex Black Panther Nemesis
The Mapex Black Panther Nemesis is a 14 × 5.5-inch snare drum on a 7-ply, 7.2mm walnut/padauk/walnut shell with die-cast hoops and staggered offset locking lugs. The padauk core between walnut plies gives it a dense, focused voice, and the die-cast hoops tighten the attack further.
Padauk in the middle
Most three-material shells put the exotic wood on the outside where it can be seen. The Nemesis does the opposite: walnut on both faces, padauk in the core. Padauk is dense and stiff, and putting it where the shell flexes most is a structural decision rather than a cosmetic one.
What comes out is a drum with a short, hard fundamental and comparatively little shell ring — the 7.2mm wall and the die-cast hoops both push the same way.
The die-cast difference
Nemesis is one of the few Black Panther snares fitted with die-cast rather than Sonic Saver hoops. A die-cast hoop is heavier and stiffer, so it damps the head edge, shortens the decay and makes the rimshot louder relative to the open note.
Against a Black Panther fitted with Sonic Saver hoops, expect less air and more crack. That is the whole design in one sentence.
Where it sits in the range
The 8 air vents are the other tell. Mapex vents Black Panther shells to taste rather than to a formula, and eight is at the open end of the range — a deliberate release valve on an otherwise very controlled drum.
Specifications
| Attribute | Value |
|---|---|
| Shell | |
| Shell material | Walnut/padauk/walnut1 |
| Plies | 7 — walnut outer and inner, padauk core1 |
| Shell thickness | 7.2 mm1 |
| Bearing edge | |
| Bearing edge | SONIClear 45°1 |
| Snare bed | 2.7 mm1 |
| Hardware | |
| Lugs | Staggered 1/8 offset locking B-lugs, 8 air vents1 |
| Hoops | Die-cast1 |
| Throw-off | Cylinder-drive strainer with micro-lock tension adjustment1 |
| model | |
| Model | BPNWP4550CKA1 |
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec