
Doc Sweeney Drums · Focus
Doc Sweeney Focus Series Snare
A 14 by 6 in maple stave snare whose interior narrows to 11 in just below the batter head, directing energy to the centre of the snare-side head. The idea comes from the Slingerland Tone Flange of the 1930s, rebuilt as one piece: the shell starts 1.5 in thick and is CNC-milled down to 0.375 in.
An old banjo idea, rebuilt
Slingerland began as a banjo maker, and its Tone Flange snare of the 1930s carried the habit over: a detachable metal flange inside the shell that reduced the internal diameter below the batter head. Doc Sweeney took the acoustic idea and dropped the bolt-on part. Here the narrowing is cut into the shell itself — a single piece of maple whose interior steps down to 11 in.
Milled away rather than built up
The shell starts as a 1.5 in thick stave blank and is CNC-machined down to a 0.375 in wall, leaving the mass where the design wants it. The extra material on the batter side gives the crack; the narrowed bore aims the energy at the middle of the snare-side head, where the wires are most responsive.
That is the whole intent. With the HolloCore covering fat and punchy, the shop wanted a drum at the other end — sensitive and highly articulate, as its own page puts it — and this is what came out. Evans Strata 1000 batter, 300 snare side, 20-strand wires, 3 mm triple-flange hoops.
Specifications
| Attribute | Value |
|---|---|
| Shell | |
| Shell material | Maple1 |
| Construction | One-piece stave shell milled from 1.5 in stock to a 0.375 in wall, with the internal diameter reduced to 11 in below the batter head1 |
| Bearing edge | |
| Bearing edge | 45 degrees, batter and snare side1 |
| Hardware | |
| Hoops | 3 mm triple flange1 |
| Snare side | |
| Snare wires | 20 strand1 |
| Origin | |
| Made in | United States — Carlsbad, California1 |
| model | |
| Based on | The Slingerland Tone Flange snare of the 1930s1 |
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec