Tama · Iron Cobra 900
Tama Iron Cobra 900 Power Glide
The Tama Iron Cobra 900 Power Glide is a double-chain-drive bass pedal built around an offset Power Glide cam, which accelerates the beater through the second half of the stroke. It runs on Oiles bearings rather than ball bearings, uses a 6mm beater shaft, and is the reference point most other pedals get compared against. Model HP900PN single, HP900PWN double.
Power Glide vs Rolling Glide
Tama sells the same pedal with two different cams, and the choice matters more than anything else on the spec sheet.
Power Glide is offset — the cam is not round, so the leverage changes as the footboard travels. It starts light and accelerates hard through the back half of the stroke. You get more power for the same effort, at the cost of a slightly less predictable feel.
Rolling Glide is round. Constant leverage, constant feel, entirely linear. Slower to build power, easier to place precisely.
Neither is better. Power Glide suits players who want the pedal to help; Rolling Glide suits players who want it to stay out of the way. If you cannot try both, Power Glide is the more popular choice by a wide margin.
Why the bearings are worth mentioning
Most pedals run on ball bearings. Tama uses Oiles bushings — a self-lubricating material rather than rolling elements. In practice that means less friction at the hinge and, more usefully, no side-to-side slop as the pedal wears.
That second part is what makes an old Iron Cobra still feel tight. It is the single most common reason players cite for buying another one after ten years with the first.
Setup notes
- Spring tension is the most over-adjusted thing on the pedal. Set it to the lightest tension that returns the beater fully, then stop.
- The beater height changes everything. Raising it slows the pedal and adds power; lowering it does the reverse. Adjust this before you touch the spring.
- Check the hoop clamp before blaming the pedal. A loose clamp presents as lost power, not as an obviously loose part.
Specifications
| Attribute | Value |
|---|---|
| Pedal | |
| Configuration | Single (HP900PN) or double (HP900PWN)1 |
| Drive | Double chain1 |
| Cam | Power Glide LiteSprocket — offset1 |
| Cam action | Increases beater power and speed toward the end of the stroke1 |
| Bearings | Oiles — lower friction than ball bearings, no side-to-side play1 |
| Beater | Power-Strike Cobra, felt, 6mm steel shaft1 |
| Heel hinge | Three-piece Hinge Guard Block; lengthens the footboard for leverage1 |
| Spring | Cobra Coil — secondary steel return spring1 |
Where to find it
Some links below are affiliate links — if you buy through one, Drum Atlas may earn a commission at no extra cost to you. Commission never affects what we list or how we describe it. Full disclosure.
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec
- 2Tier 2 · Highretailer listing