
Remo · Powerstroke 4
Remo Powerstroke P4 Coated
The Remo Powerstroke P4 Coated is two plies of 7-mil coated film with a 3-mil inlay ring. Two plies self-damp and the ring takes the edge overtones off, so the head gives controlled sustain and focused low-end tones with increased durability. Remo calls it the warmest of its two-ply coated bass drum heads.
Powerstroke, on two plies
The number in the name is the giveaway. P3 is a single ply with a perimeter ring. P4 is two plies with a perimeter ring — here two of 7-mil coated film with a 3-mil ring.
So this head damps itself twice over, by two independent mechanisms.
The two plies are not bonded across their surface, so they move slightly against each other as the head vibrates and turn that movement into heat. That is what makes any Emperor shorter and fatter than an Ambassador.
The inlay ring damps the perimeter, where the head’s high, tight overtones live, leaving the fundamental at the centre intact.
Neither one is a blanket. Together they produce Remo’s stated result: controlled sustain and focused low-end tones.
A light ring, on purpose
Three mil, where the single-ply P3 bass heads carry 10. That is not a downgrade — it is a consequence.
The two plies have already removed most of what a heavy ring would be removing. Bolting a 10-mil ring onto an already self-damping head would push it past controlled and into dead, so Remo uses the lighter ring to finish the job rather than to do all of it.
Toms as well as bass
Remo lists this from 8 inch to 26 inch, and names toms and bass drum both. That is a wide span for one construction and it is genuinely useful: a kit with P4 Coated on the toms and on the bass batter has the same damping behaviour throughout, which makes the whole kit sound like one instrument.
On toms it gives a short, thick, punchy note with almost no ring — the sound of a great deal of hard rock recording. On a bass drum it gives a controlled thud that needs little or no muffling inside.
The warmest of the two-ply coated bass heads
Remo’s claim, and the construction supports it. Two plies of 7 mil is the standard Emperor weight rather than a heavy one, the ring is light, and the coating rounds the attack. Nothing in the head is trying to be bright.
Where it fits
Toms and bass drums for hard rock and anywhere minimal sustain is wanted. The clear P4 keeps more attack; the plain coated Emperor is the same two plies without the ring.
Specifications
Where to find it
Some links below are affiliate links — if you buy through one, Drum Atlas may earn a commission at no extra cost to you. Commission never affects what we list or how we describe it. Full disclosure.
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec