Drum Atlas
Menu

Evans · Genera HD

Evans HD

  • Drumhead
  • pro
  • current

The Evans HD — Heavy Duty — is a two-ply snare batter built from a coated 5 mil outer ply over a 7.5 mil inner ply, with a 2 mil control ring underneath. Evans gives it a slightly more defined attack, short sustain and a moderately bright tone, damping excess overtones without drying the head out.

Updated 2026-09-24Sources

Two unequal plies

Most two-ply heads use matched plies. The HD does not: a thin 5 mil ply on top, a thicker 7.5 mil ply underneath. The thin top ply keeps the head responsive to a light stroke and to brushes, and the thicker ply under it carries the load when the stick comes down hard.

That split is the whole design. A matched pair of 7s gives you a uniformly stiffer head; unequal plies let the top surface stay sensitive while the drum as a whole gets tougher.

The ring

Underneath sits a 2 mil control ring around the perimeter. It is a light one by the standards of the range — an EC2 carries a much heavier damping system — and Evans is specific that the job is damping excessive overtones just enough to balance the sound, not removing them.

The result Evans describes is a slightly more defined attack, a short sustain and a moderately bright tone. On a snare that means a clear backbeat with the ring trimmed rather than killed, which is why this head turns up on a lot of studio kits.

The HD Dry is the same build with precision-drilled vents around the perimeter, which takes the overtone control further.

Specifications

Specifications
AttributeValue
Heads
Plies21
Film thickness5 + 7.5 mil1
CoatingCoated1
PositionBatter1Evans lists the HD as a snare batter; the HD Dry is also offered as a tom batter.
Dampening2 mil control ring on the underside1
CollarLevel 3601

Sources

Numbered footnotes in the spec table point here.

  1. 1Tier 1 · Primarymanufacturer spec

    HD Snare Batter Drumhead

    Evans / D’Addario · accessed 2026-09-24