
Attack · Proflex 1
Attack Proflex 1 No Overtone
The Proflex 1 No Overtone is Attack’s coated 10 mil Dynaflex single ply with an internal No Overtone ring. Attack gives it a bright, articulate voice with a clean, controlled response and balanced sustain, finished in DuraCoat Matte White, and builds it as a 14 inch snare batter.
A ring instead of a second ply
There are two ways to stop a snare drum ringing, and they do not sound alike. A second ply of film changes the whole response — harder attack, less sensitivity at low volume. An internal ring around the perimeter leaves the middle of the head untouched and takes out the edge modes, which is where most of the unwanted ring lives.
Attack calls theirs the No Overtone ring and bonds it inside the head. The result they claim is a clean, controlled response with balanced sustain, which is the right description for ring damping rather than mass damping — the note is trimmed, not shortened.
Still a single ply underneath
Under the ring it is the same coated 10 mil Dynaflex as a standard Proflex 1, so it keeps the bright articulate voice and the sensitivity a single ply gives you. For a lot of players that is the whole appeal: a controlled head that still answers a ghost note.
Attack applies the same idea across the kit. The No Overtone Ported is a 10 mil black bass drum head with the ring and a pre-cut four inch port; the Bomb Beat is a two-ply bass head with an oversized four inch version of the ring; and the Baron and Radioactive carry a smaller Micro No Overtone ring under a dot.
Specifications
Sources
Numbered footnotes in the spec table point here.
- 1Tier 1 · Primarymanufacturer spec