
Pearl · Session
Pearl Session Studio Select
Session Studio Select is Pearl's birch and mahogany kit: six plies at 5.4 mm with a 60-degree bearing edge, high-gloss lacquered shells, 2.3 mm SuperHoop II hoops and free-swinging Optimount tom mounts. The two woods give a warm, full tone with a precise attack.
A note on sourcing
Pearl’s own website is not reachable from this project — blocker B6 — so every figure here comes from a retailer listing and is marked unverified.
Birch and mahogany, a studio pairing
Birch has a natural upper-midrange lift and a controlled low end, which is why it has been the studio wood of choice for half a century: it sits in a mix without EQ. Mahogany is its opposite — soft, dark, quick to absorb high overtones.
Combining them in one six-ply shell gives a drum with birch’s attack and definition over mahogany’s warmth underneath. That is a well-established recipe rather than a novel one, and it is the reason this kit carries “Studio” in its name.
Thin, at 5.4 millimetres
Five point four millimetres across six plies is a thin shell — noticeably thinner than the 7.5 mm Masters Maple above it in the range. A thinner shell moves more, which means more of the sound comes from the shell and less from the head: a lower fundamental, a warmer character and a quicker decay.
Pearl pairs that with a 60-degree bearing edge, the broader of its two cuts, which puts more head on wood and strengthens the fundamental further. Both decisions push in the same direction.
SuperHoop II and Optimount
The 2.3 mm SuperHoop II is a triple-flanged hoop of above-average thickness — stiffer than a standard 1.6 mm hoop, so tuning is more even, but lighter and more open than a die-cast one. On a thin shell that is the right choice: a die-cast hoop would take away the resonance the thin shell was chosen to provide.
Optimount holds the tom clear of the shell entirely, for the same reason.
Where it fits
Between the Export and the Masters in Pearl’s range, and tonally closer to a vintage kit than to either. The five-piece pack with two floor toms is the configuration a studio would want.
Specifications
| Attribute | Value |
|---|---|
| Shell | |
| Shell material | Birch and mahogany1*Pearl's own site is not reachable for this project; the specification comes from a retailer listing. |
| Plies | 61*Retailer-stated. |
| Shell thickness | 5.4 mm1*Retailer-stated. |
| Bearing edge | |
| Bearing edge | 60 degrees1*Retailer-stated. |
| Hardware | |
| Hoops | SuperHoop II, 2.3 mm1*Retailer-stated. |
| Tom mount | Free-swinging Optimount1*Retailer-stated. |
| Heads | |
| Stock heads | Remo Clear1*Retailer-stated. |
| Build | |
| Sizes shown | The STS925XP five-piece shell pack; a snare is bought separately1* |
- *Not yet checked against a published source. Where a numbered source is given, it is on record but has not been opened and confirmed. See how we source.
Where to find it
Some links below are affiliate links — if you buy through one, Drum Atlas may earn a commission at no extra cost to you. Commission never affects what we list or how we describe it. Full disclosure.
Sources
Numbered footnotes in the spec table point here.
- 1Tier 2 · Highretailer listing