Drum Atlas
Menu

Pearl · Reference

Pearl Reference One

  • Drum kit
  • flagship
  • current

Reference One is Pearl's shell-per-drum flagship: every drum in the kit uses a different wood recipe chosen for its size and job, so a bass drum is mahogany with maple, a 10 in tom is maple with birch and a 12 in tom is all maple. MasterCast hoops, STL-100 lugs and the R2 air suspension system are common across it.

Updated 2026-09-24Sources

A note on sourcing

Pearl’s own website is not reachable from this project — blocker B6 — so every specification here comes from a retailer listing and is marked unverified. The per-drum ply breakdown below is the retailer’s, and it is unusually detailed for a retail listing, but it has not been checked against a Pearl page.

A different shell in every drum

The Reference concept is that one shell recipe cannot be right for every drum in a kit, because the drums are not doing the same job. Reference One applies that literally:

  • 22 x 16 in bass drum — six plies of mahogany with two of maple. Mahogany is soft and dark, which suits a drum whose job is low-frequency weight rather than attack.
  • 10 x 7 in tom — four plies of maple with two of birch. Birch adds the upper-mid lift a small tom needs to be heard over the rest of the kit.
  • 12 x 8 in tom — six plies of maple. The most neutral drum in the kit, in the middle of its range.
  • 16 x 16 in floor tom — four plies of mahogany with two of maple. Back towards mahogany for warmth as the drum gets larger and lower.

The logic runs in one direction: more mahogany as the drums get bigger and lower, more birch as they get smaller and higher, maple as the constant. It is a coherent position and an unusual one to execute across a whole range.

Why anyone would bother

A conventional kit is one wood recipe scaled up and down. That works because maple is versatile, but it means the bass drum and the 10 in tom are built as if they had the same requirements.

Voicing the shells separately is more expensive to manufacture — four recipes instead of one — and the payoff is a kit whose drums are individually suited rather than collectively adequate. Pearl has held the idea across several generations of the Reference range, which is a fair indication it works.

Hardware

MasterCast die-cast hoops throughout tighten the notes and even out the tuning; STL-100 lugs and the R2 air suspension mount with a 12 mm L-rod are the Pearl flagship fittings.

Against Masters Maple

Masters is one wood done well. Reference One is four woods placed deliberately. The Masters kit is the more neutral and the easier to predict; Reference One is the more considered.

Specifications

Specifications
AttributeValue
Shell
Shell materialMaple, birch and mahogany, varied by drum1*Pearl's own site is not reachable for this project; the specification comes from a retailer listing.
Plies8-ply bass drum; 6-ply toms and floor tom1*The bass drum is six plies of mahogany with two of maple; the 10 in tom is four plies of maple with two of birch; the 12 in tom is six plies of maple; the 16 in floor tom is four plies of mahogany with two of maple.
Hardware
HoopsMasterCast die-cast1*Retailer-stated.
LugsSTL-1001*Retailer-stated.
Tom mountR2 air suspension with a 12 mm L-rod mount1*Retailer-stated.
Heads
Stock headsRemo1*Retailer-stated.
Build
Sizes shownThe 22 in four-piece shell pack1*
  • *Not yet checked against a published source. Where a numbered source is given, it is on record but has not been opened and confirmed. See how we source.

Where to find it

Some links below are affiliate links — if you buy through one, Drum Atlas may earn a commission at no extra cost to you. Commission never affects what we list or how we describe it. Full disclosure.

Sources

Numbered footnotes in the spec table point here.

  1. 1Tier 2 · Highretailer listing

    Pearl Reference One 22" 4pc Set #816

    Thomann · accessed 2026-09-24