---
title: "Yamaha HS-1200 Hi-Hat Stand"
brand: "Yamaha"
category: "Hardware"
url: "https://thedrumatlas.com/hardware/yamaha-hs1200-hi-hat-stand"
updated: "2026-09-11"
reviewed: "yes"
---

# Yamaha HS-1200 Hi-Hat Stand

The Yamaha HS-1200 is a three-leg hi-hat stand with an unusual compromise: the front two legs are single braced to leave room for a second pedal, while the rear leg is double braced and carries a retractable spike. It ships with two pull rods of different lengths.


## Specifications

| Attribute | Value | Status | Source |
|---|---|---|---|
| Type | Hi-hat stand | verified | Yamaha |
| Legs | Three — front two single braced, rear double braced | verified | Yamaha |
| Rear leg | Retractable spike | verified | Yamaha |
| Height range | 80–92 cm | verified | Yamaha |
| Clutch | Locking — holds with a very loose top cymbal | verified | Yamaha |
| Pull rods supplied | Two — a short rod for open-hand technique and a longer one for higher setups | verified | Yamaha |
| Connecting rod | Straight, with rubber insert | verified | Yamaha |
| Cymbal support | Hard rubber and felt | verified | Yamaha |
| Rotating legs | Yes | verified | Yamaha |
| Footboard angle | Adjustable | verified | Yamaha |

## A third answer to the double pedal problem

Two legs or three is usually presented as a binary. Yamaha declines it.

The HS-1200 keeps **three** legs — so the stand stays properly planted — but braces them
differently. The two front legs are **single braced**, which makes them physically slimmer and
frees up the floor space where a double pedal's slave needs to sit. The rear leg is **double
braced** and carries a retractable spike, so the load-bearing leg is the strong one and it grips
the floor.

It is a genuinely clever piece of reasoning: the stability of a tripod mostly comes from the
footprint, not from every leg being maximally strong, and the leg doing the real work is the one
behind you.

For a player who wants a double pedal *and* a stand that does not shift, this is the most sensible
design in the catalogue.

## Two pull rods in the box

The pull rod connects the footboard to the clutch, and its length sets how high the hi-hats can
sit.

Yamaha supplies **two**. The short one is for players using **open-hand technique** — playing the
hats with the left hand rather than crossing over — where the cymbals sit low and out of the way of
the snare. The long one is for conventional crossed-hand setups with the hats up high.

Supplying both is unusual and worth noticing. Open-hand players normally have to buy a shorter rod
separately or live with a stand that will not come down far enough.

## The locking clutch

The clutch is the assembly that holds the top cymbal on the pull rod, and Yamaha's specific claim
here is that it will not come loose **even if you play your top cymbal very loose**.

That case is the hard one. A loosely mounted top hat — deliberately slack so it sloshes and
breathes — puts far more vibration through the clutch than a tightly clamped one, and ordinary
clutches gradually undo themselves under it. The cymbal ends up sitting on the bottom hat halfway
through the set.

If you like a loose top cymbal, this is the specification that matters on the whole stand.

## Rubber and felt

The cymbal support is hard rubber with felt, and the combination is doing two jobs.

**Felt** under the top cymbal lets it move freely and stops metal touching metal. **Hard rubber**
on the bottom cup supports the lower cymbal without damping it into silence — a soft rubber cup
absorbs so much that the bottom hat stops contributing, which is a surprisingly common way to make
hi-hats sound dead.

Both are consumables. Felt washers compress and harden over years, and replacing a set that has
gone hard is one of the cheapest improvements available to a hi-hat sound.

## Sources

1. HS-1200 Double Braced Hi-Hat Stand — Yamaha (tier 1) https://shop.usa.yamaha.com/en/p/instruments/drums-percussion/drum-hardware/hs-1200-double-braced-hi-hat-stand
2. Yamaha HS-1200 1200 Series 3-Leg Hi Hat Stand — Memphis Drum Shop (tier 2) https://drumcenternh.com/products/yamaha-hs-1200-1200-series-two-single-one-double-braced-hi-hat-stand

---
Source: https://thedrumatlas.com/hardware/yamaha-hs1200-hi-hat-stand · Values marked "unverified" are editorial knowledge awaiting a source.
